Roof Panel Joint Finish Molding Clip Replacement
Document Preview
Repair Procedure
To remove the damaged clip, heat under hot air (minimum 100°C (212°F), until the tape is soft and pliable.
Remove the clip with fine tweezers, being careful not to damage the body panel.
- Note:
Use a fine nozzle attached to the dryer to avoid damage to the body painted su...
Attention!
To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.
Notice!
You may preview the service manual table of contents by clicking below.