Endgate Upper Finish Molding End Cap Replacement (H3T)

Document Preview

2009 H3T Endgate Upper Finish Molding Endcap Replacement

Callout

Component Name

Preliminary Procedure

Open the end gate in order to access one end of the upper finish molding end cap.

1

Endgate Upper Finish Molding End Cap

Tip

Pull upward on one end of the end cap in order to release the integral retainers from the endgate assembly.

Attention!

To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.

Subscribe

Notice!

You may preview the service manual table of contents by clicking below.

Service Manual Table of Contents