Propeller Shaft Phasing Inspection

Document Preview

Special Tools

J-23498-A Driveshaft Inclinometer, or equivalent

Note:

This inspection procedure is intended to inspect propeller shaft systems with 2 or 3 U-joints only.

Correct phasing of a propeller shaft refers to the relative alignment of the U-joint yoke flanges to each other...

Attention!

To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.

Subscribe

Notice!

You may preview the service manual table of contents by clicking below.

Service Manual Table of Contents

Document Tags

Document Title: Propeller Shaft Phasing Inspection

adriveshaft

inclinometer

equivalent

propeller

shaft

phasing

joint

yoke

vehicle

rotate

bearing

prop

rear

difference

welded

degrees

joint bearing

prop shaft

welded yoke

degrees propeller

inclinometer equivalent lower

inclinometer equivalent horizontal

equivalent horizontal reference

welded yoke propeller

yoke propeller shaft

propeller shaft degrees

degrees propeller shaft

shaft properly phased

propeller shaft greater

shaft greater degrees

greater degrees propeller

propeller shaft constructed

shaft constructed improperly

constructed improperly damaged

improperly damaged twisting

damaged twisting propeller

twisting propeller shaft

propeller shaft phasing

shaft phasing correction

difference welded yoke

welded yoke slip

yoke slip yoke