Electronic Brake Control Module Programming and Setup

Document Preview

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

  • EBCM Reprogramming—Refer to Service Programming System (SPS).

  • Revise the yaw rate sensor recalibration using the Scan Tool yaw rate recalibration function.

  • Revise the...

Attention!

To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.

Subscribe

Notice!

You may preview the service manual table of contents by clicking below.

Service Manual Table of Contents

Document Tags

Document Title: Electronic Brake Control Module Programming and Setup

ebcm

revise

rate

sensor

recalibration

using

scan

tool

function

tire

calibration

following procedures performed

rate recalibration function

revise tire calibration

tire calibration using

calibration using scan

scan tool tire

tool tire size

rate sensor lateral

sensor lateral accelerometer