Key and Lock Cylinder Coding

Document Preview

Ignition Lock Cylinder

The ignition lock cylinder uses only 7 of the 10 cut positions, 2 through 8. The ignition cylinder tumblers (3) are located on alternate sides of the cylinder (1). They are snap-in and self-retaining. It follows the key code with the first tumbler being the first...

Attention!

To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.

Subscribe

Notice!

You may preview the service manual table of contents by clicking below.

Service Manual Table of Contents

Document Tags

Document Title: Key and Lock Cylinder Coding

ignition

lock

cylinder

located

code

first

tumbler

closest

head

spring

insert

spring

spring

assembly

loaded

position

install

slot

over

remaining

following

process

pressing

place

secure

rotate

correct

loading

inserting

flush

using

grease

retainer

door

lever

wells

check

detent

assemble

insert tumbler

cylinder assembly

over spring

install remaining

code process

tumblers place

assembly insert

loading tumblers

tumblers inserting

cylinder tumblers

flush lock

door lock

spring wells

lock cylinder uses

cylinder uses cut

uses cut positions

cut positions through

pockets cylinder assembly

code install first

install first tumbler

first tumbler slot

tumbler slot over

slot over spring

over spring install

spring install remaining

install remaining tumblers

remaining tumblers cuts

tumblers cuts following

code process pressing

process pressing tumblers

pressing tumblers place

tumblers place secure

rotate cylinder assembly

cylinder assembly insert

correct loading tumblers

loading tumblers inserting

flush lock cylinder

door lock cylinder

tumblers spring wells

spring wells faces

press tumblers place

check correct loading

cylinder tumblers flush

tumblers flush lock

lock cylinder body