Oxygen Sensor Replacement
Document Preview
Removal Procedure
- Notice:
The O2S-1 uses a permanently attached pigtail and connector. This pigtail should not be removed from the O2S-1. Damage or removal of the pigtail or connector could affect proper operation of the O2S-1.
Turn the ignition OFF.
Disconnect the O2S-1 harness co...
Attention!
To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.
Notice!
You may preview the service manual table of contents by clicking below.