Engine Cranks But Does Not Run (Chart 4 of 4)

Document Preview

Circuit Description

Schematic

In order to control spark and fuel, the PCM must receive pulses from the crankshaft position sensor. The scan tool should always display RPM whenever the engine is running or cranking above 60 RPM. This chart will isolate the cause of crank pulses not being received by th...

Attention!

To view the rest of this document requires a subscription. Subscriptions start at only $15.00. Click the button below to view the subscription options and to sign up.

Subscribe

Notice!

You may preview the service manual table of contents by clicking below.

Service Manual Table of Contents

Document Tags

Document Title: Engine Cranks But Does Not Run (Chart 4 of 4)

crankshaft

position

sensor

resistance